1. Follow the procedure for Tying A Full Bale before proceeding.

2. Position a pallet in the opening of the unload door. The bale will be tipped on to the pallet 

during the bale eject process.

3. Verify the ram is located within the upper and lower limits of Decal #190 from the Decals 

section.

4. Grab the red and black handle located in the center of the ram.

5. Pull up on the black handle and push the red ejector slide back until it makes contact with the 

rear wall of the chamber.

6. Turn and hold the keyed selector switch to the “HAND” position and press the yellow “UP” button. 

The ram will go up and tip the ejector strap forward, tipping the bale onto the pallet. Move the 

ram up all the way to cancel the bale ejector handle and strap.

7. Coat the inside of the chamber with paraffin wax.

8. Place a flat sheet of cardboard on the floor of the camber to prepare for the next bale.